Curved molding
Trim following a curved wall or opening, built from straight segments with mitered ends, sawn from flat stock, or kerf bent. Kerf details are in the kerf bending calculator.
Curve by
0 for one piece
Lengths and cuts
- Inside radiusoutside 3' 3", centre line 3' 1 1/2"
- 3' 0"
- Sweepchord 4' 2 15/16", rise 10 9/16"
- 90.00°
- Developed length4' 8 9/16" inside, 5' 1 1/4" outside
- 4' 10 7/8"
- Segmentslong point to long point outside; 1' 2 1/16" inside; each turns 22.50°
- 4 × 1' 3 3/16"
- End mitersfrom square, both ends of every segment
- 11.25°
- Blank for a curved facesaw the face to R 3' 3" outside and R 3' 0" inside
- 1' 3 3/16" × 3 3/4"
Plan
Curved molding plan
Printing uses the real sizes. Set the printer scale to 100% and check one dimension with a tape before cutting.
Segment template
One segment inside its flat blank: miter both ends at 11.25°, then saw the curved faces to the two radii. True size when it fits the sheet.
Molding segment
Printing uses the real sizes. Set the printer scale to 100% and check one dimension with a tape before cutting.
The link carries every input, so it opens the same calculation on a phone.