Roof shape
One slope from a low wall to a high wall, as on a shed, lean-to or mono-pitch addition. Cutting templates for any of the rafters are in the common rafter calculator.
Slopes as
Slope from
Rafter
Lengths and cuts
- Roof angle3:12 pitch
- 14.04°
- Riseover the span, low wall to high wall
- 3' 0"
- High wall heightlow wall 8' 0", difference 3' 0"
- 11' 0"
- Line lengthwall to wall along the rafter
- 12' 4 7/16"
- Tailslow end · high end, along the rafter
- 1' 3/8" · 1' 3/8"
- Overall length
- 14' 5 3/16"
- Rafter plumb cutsaw miter from square · length of the cut
- 14.04° · 7 1/2"
- Rafter seat cutheel 7/8", HAP 6 5/8"
- 75.96° · 3 1/2"
- Roof areaover 20' 0" of building
- 288.62 sq ft
Cross section
Skillion, 12' 0" span at 3:12 (14.04°)
Printing uses the real sizes. Set the printer scale to 100% and check one dimension with a tape before cutting.
Lumber: nominal to actual
Enter actual finished sizes in every tool. A nominal 2x4 is cut and dressed to the size shown.
| Nominal | Actual |
|---|---|
| 1x2 | 3/4" x 1 1/2" |
| 1x3 | 3/4" x 2 1/2" |
| 1x4 | 3/4" x 3 1/2" |
| 1x6 | 3/4" x 5 1/2" |
| 1x8 | 3/4" x 7 1/4" |
| 1x10 | 3/4" x 9 1/4" |
| 1x12 | 3/4" x 11 1/4" |
| 2x2 | 1 1/2" x 1 1/2" |
| 2x3 | 1 1/2" x 2 1/2" |
| 2x4 | 1 1/2" x 3 1/2" |
| 2x6 | 1 1/2" x 5 1/2" |
| 2x8 | 1 1/2" x 7 1/4" |
| 2x10 | 1 1/2" x 9 1/4" |
| 2x12 | 1 1/2" x 11 1/4" |
| 4x4 | 3 1/2" x 3 1/2" |
| 4x6 | 3 1/2" x 5 1/2" |
| 6x6 | 5 1/2" x 5 1/2" |
The link carries every input, so it opens the same calculation on a phone.